![]() When attached to frame work, lattice panels are extremely versatile and can even be used as a trellis, gate, or fence to boost privacy. If you are purchasing lattice panels for an outdoor project, such as a trellis or a privacy fence, the strips may be as wide as six inches. Generally speaking, the standard width of the lattice strips is usually three or four inches, although half inch thin strips are available for smaller projects. ![]() The width of strips of lattice will vary depending on the size of the lattice panel you purchase. Generally, it is advised to wear safety glasses and a dust mask when cutting lattice to size.Īdditionally, it is important to plan out the cuts before beginning the project to make the process easier and quicker. When cutting metal lattice, a hacksaw or circular metal saw is the best bet. For vinyl lattice, a handheld circular saw or a powered miter saw can be used to make straight cuts.Ī hole saw can also be used to carve out circles. It is typically made of vinyl, wood, or metal, and each material can be cut using the appropriate tools. You may also want to double-check the limits of the cutting service at that particular Home Depot store, as some stores may not be able to cut wood lattice larger than 4×8 feet. When you make your purchase, talk to an associate about having the wood lattice cut to your specific measurements. Keep in mind that not all Home Depot locations may carry wood lattice-be sure to check with your local store ahead of time to see if they will be able to accommodate your needs. This cutting service is provided free of charge with purchase at most store locations. Yes, Home Depot often cuts wood lattice for customers. Does Home Depot cut wood lattice for you? For visual appeal, thinner lattice will be lighter and more decorative, with 1/8 inch being the thinnest option. If you are looking for extra strength and durability, it is recommended to use a thicker lattice, with 1/2 inch being the thickest possible. There are a variety of materials such as plastic, vinyl, wood and metal that lattice can be made from, so the thickness and sturdiness of the lattice can vary considerably. So far, the plastic panels have been used mostly by contractors and home builders.Lattice comes in various thicknesses, ranging from 1/8 inch to 1/2 inch, depending on the type of material and the desired outcome. Many home centers and lumberyards stock lattice panels of pressure-treated wood, but plastic panels are more difficult to find at retail outlets because they are relatively new. Wax the bolt ends and wingnuts to retard rust. ![]() Drill 3/8-inch holes at the bolt locations, slip the panel over the bolt ends, and hold the panel in place with a washer and wingnut on each bolt. After the glue dries thoroughly, hold the panel in place against the protruding ends of the bolts and tap with a mallet to make impressions of the bolt ends on the panel frame. Cut the heads off several bolts and use an epoxy to glue the cut ends into holes drilled in the deck or porch framing at points where the panel is to be attached. The bolts should be five-sixteenths-inch thick and about 1 1/2 inches longer than the thickness of the panel frame. One way to attach a lattice panel so it is easily removed for access to a space is to use bolts and wingnuts.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |